23

Regulatory Information

Declaration of Conformity

Trade Name:

2Wire

Responsible Party:

2Wire, Inc.

Address:

1704 Automation Parkway

San Jose, CA

Telephone:

408.856.1600

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device

may not cause harmful interference, and (2) this device must accept any interference received, including interference

that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of

the Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged

to try to correct the interference by one or more of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and the receiver.

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•

Consult the dealer or an experienced radio/TV technician for help.

You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to

operate this equipment.

Only peripherals (computer input/output devices, terminals, printers, and so forth) that comply with FCC Class B limits

may be attached to this computer product.

Operation with noncompliant peripherals is likely to result in interference to radio and television reception.

WARNING:

While this device is in operation, a separation distance of at least 20 cm (8 inches) must be maintained

between the radiating antenna inside the ERU and the bodies of all persons exposed to the transmitter in order to meet

the FCC RF exposure guidelines. Making changes to the antenna or the device is not permitted. Doing so may result in

the installed system exceeding RF exposure requirements. This device must not be co-located or operated in

conjunction with any other antenna or radio transmitter. Installers and end users must follow the installation

instructions provided in this guide.

FCC Part 68

This equipment complies with Part 68 of the FCC rules. On the bottom of this equipment is a label that contains,

among other information, the FCC equivalence number (REN) for this equipment. If requested, this information must be

provided to the telephone company.

The REN is used to determine the quantity of devices that may be connected to the telephone line. Excessive RENs on

the telephone line may result in the devices not ringing in response to an incoming call. In most, but not all areas, the

sum of the RENs should not exceed five. To be certain of the number of devices that may be connected to the line, as

determined by the total RENs, contact the telephone company to determine the maximum REN for the calling area.

Regulatory Information

24

If the terminal equipment causes harm to the telephone network, the telephone company will notify you in advance that

temporary discontinuance of service may be required. But if advance notice is not practical, the telephone company will

notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you

believe it is necessary.

The telephone company may make changes in its facilities, equipment, operations or procedures that could affect the

operations of the equipment. If this happens, the telephone company will provide advance notice in order for you to

make the necessary modifications in order to maintain uninterrupted service.

If trouble is experienced with this equipment, please contact the store, reseller, or agent from whom the product was

purchased.

Repair of this equipment should be made only by the 2Wire Service Center or a 2Wire authorized agent.